Hi everyone!
I’m happy to share my latest 3D printing project: a fully redesigned case for the M5Stack Cardputer (all versions) that also accommodates several of its accessories — so you can have everything in one place, ready to go.
What’s included
The case is designed to fit the Cardputer ADV along with a selection of add-on modules, including:
- M5Stack RF Unit 433MHz (TX/RX)
- RFID 2 Unit
- GPS/BDS Unit
- MIDI Synthesizer Unit
- IR Emitter/Receiver
- I2C Hub 1-6
- Grove cables (various lengths)
- LoRa868 GNSS Cap for Cardputer-ADV
Print settings
- Layer height: 0.2 mm
- Walls: 2
- Infill: 10%
- Material: PETG recommended (any material works fine)
- Assembly: 2x M3x25mm screws + 2x M3x30mm screws
The case features well-designed hinges and a snap lock that works best in PETG. It was fully redesigned from scratch, inspired by existing single-device cases on MakerWorld.
Download
The model is free and available on MakerWorld:
https://makerworld.com/it/models/2112823-cardputer-adv-case-accessories#profileId-2285958
Feedback, remixes and suggestions are very welcome! Happy making!